In this window you should also choose the Sample Rate of the File you are about to record.Click on the General Tab and choose ports for the Playback and Recording Timing Master settings. After restarting, go back to the Audio menu.This will require a restart of the application.
#Sonar 8 problems drivers
#Sonar 8 problems driver
Click on the Advanced tab at the top of the window and choose either MME, WDM, or ASIO from the Driver Mode (only found in Sonar 2.2 or above).When the profiler is complete, Sonar will resume opening. If you are using your MOTU audio interface for the first time with Sonar, you may be prompted to run the Wave Profiler upon launching the application.
If you are using any ADAT lighpipe devices, enable the ADAT I/O ports you wish to use with Sonar. Open the MOTU Audio Setup before accessing Sonar.Ĭlick on the General tab and set the clock source to Internal (if there are no digital devices connected to your interface's digital inputs). In order to access the inputs and output sources, Enable Routing must be checked.Įnable the inputs and outputs you wish to use from Sonar. Set the clock source to Internal (if there are no digital devices connected to your interface's digital inputs).Īssign the bank you intend on using, for example, with a 2408mk3 choose analog for Bank A, ADAT for Bank B, and SPDI for Bank C. Open MOTU PCI Audio Setup before accessing Sonar.
#Sonar 8 problems manual
* For additional connections with digital devices you can refer to your Hardware manual for further instructions. In order to access the inputs and output sources, "Enable Routing" must be checked.Įnable the inputs you wish to use and assign the output sources you also wish to use to "From Computer." Set the clock source to Internal (if there are no digital devices connected to your interface's digpital inputs).Īssign the bank you intend on using, for example, with a 2408mkII choose analog for Bank A, ADAT for Bank B, and SPDIF for Bank C. Open the MOTU PCI-324 Console before accessing Sonar. Consult Cakewalk for recommendations as to which driver to use with your setup. By doing so, you will have access to either the MME, WDM, or the ASIO driver. When running the MOTU Core or FireWire CD installer choose the Multimedia Audio Driver and ASIO drivers. Within the past few years Sonar has introduced WDM and ASIO support, both of which are supported by MOTU audio interfaces. These instructions apply to Sonar, as well as other current generation Cakewalk software applications.Ĭakewalk audio programs have always supported legacy wave audio (MME).
Here are basic instructions to help get you started with Cakewalk software, such as Sonar, using MOTU audio interfaces.
0 kommentar(er)
